Gravity Casting
Equipment Menu About Us Contact


Up

Gravity casting machines for aluminum


 

NAL Series: Constructed in a "C" shaped frame, this is a very ridged machine.  An upper bridge can be fitted for upper core pulls.  Each die platen is affixed with four post guides and closure is guided and aligned mechanically.  

Siemens S7 controller and OP keypad allow for programming and storage of up to 99 varied machine cycles

Optionally, front and rear core pulls can be used, as well as frontal and rear die closure for multiple die configurations.  Axial metal core can be programmed for automatic operation during the pour cycle. This casting machine is designed for frontal pour.  The picture show here is with the top and rear core Rotating bed machine
  • Prepared for lower core 
  • 1200 mm distance between platens
  • 600 x 800 mm Die platens
  • Prepared for front, rear, and top bridge 

AL Series:  Constructed in a "C" shaped frame, this is a very ridged machine.  An upper bridge can be fitted for upper core pulls.  Each die platen is affixed with four post guides and closure is guided and aligned mechanically.  

Siemens S7 controller and OP keypad allow for programming and storage of up to 99 varied machine cycles

Optionally, front and rear core pulls can be used, as well as frontal and rear die closure for multiple die configurations.  Axial metal core can be programmed for automatic operation during the pour cycle.
  • Fixed bed machine, non-tilting
  • Prepared for lower core 
  • 1000 mm distance between platens
  • 600 x 800 mm Die platens
BLA Series:  This casting machine is constructed the same as the NAL, with all the same features and controls.  But unlike the frontal pouring NAL series, this is a lateral pour casting machine.
  • One fixed plated, one moving platen
  • 90 Degree lateral tilt 
  • 1200 mm distance between platens
  • 800 x 800 mm Die platens
  • Upper bridge available for top core

The ALS Series is a tilt bed casting machine, for up to four die sections.  Max casting die size: 400 x 400 x 400 mm.

This casting machine can be fitted with automatic dosing and casting removal.

Also available:  ALS 4 / 600 and ALS 4 / 1200.

  • 40 degree tilt
  • Complete with upper and lower core units
  • automatic dipping of upper core
  • 2, 3, or 4 part casting dies
  • 1000 mm table
 

 


 

Page last modified: March, 2015  

2015 Sawyer and Smith Corporation